500 eyelets in brass . For use with the Rhino Red Grommet Kit with eyelet dies.
Eyelets are very small grommets. They do not need any washers.
You install the special dies, pierce the vinyl and then press the eyelet down with the Rhino Red Grommet Press.
Use to roll down vinyl graphics for paper tape or SpeedPress® applications. Solid cast aluminum frame, 1 inch steel axle. This roller is custom made to withstand constant daily use by SpeedPress® signmakers. Very smooth operation, 4.5’ rubber roller.
Roll this over a dusty surface and it magically picks up every particle, then roll it on the included tacky pad and its ready to use again. Also used as a general purpose 12 inch soft roller to lay down prints and SpeedPress® down vinyl.
This tool comes in very handy when you need a harder edge than the plastic squeegee. Steel blade is 3" wide. Anti-friction coated. Steel handle, stiff blade.
Use to squeegee paper transfer tape to vinyl lettering. One pass covers three times the area of a conventional plastic squeegee. Premask at triple speed! Stainless steel blade, molded plastic body 11.5" length.
Signmaker's secret tool to get lines lettering on straight. Make a perfect sign faster without rulers. 8" long dividers open to 14". Self-centering gearhead, chrome finish.
The ATG tape gun lays down a smooth line of double faced tape exactly where you want it and it removes the tape liner automatically. Trigger action with gear driven take up reels. Always used with micro thin ATG tape.
Cuts uniform 2.8" to 12" diameter circles Coroplast, Foamcore™, Sintra™ and banner vinyl. Perfect for wind slits. Blade and center pin are adjustable for depth according to thickness of materials.
This is our new favorite knife. Open the compartment door and load a full mag of 35 blades. Press the button and pull out the old blade. Rack the slide and out pops a fresh blade .... amazing. Fully retractable, the blade can be set in 3 positions. Rubber grips. Uses standard blades.
View Cart
See All Products
Sign Holders
Back to the top
